Alamo Axtreme 02984405 - Manual (Page 82)

Axtreme Boom (Asy Man) 07/06
© 2006 Alamo Industrial
Section 8- 10
Battery
Brown Wire of Harness
Cut Tractor Starter
Wire to Starter Sole-
noid and reroute
through Joystick
Harness Brown
wires.
ACC Wire
Brown Wire of Harness Red Wire of Harness
Starter
Black Wire Ground
Tractor Ignition Wire
Shown here is typical Ignition
connection, Your Ignition may
vary but the function will not.
Wiring
Harness
Tractor
Ignition Switch
Ignition
FIGURE 15
Wiring Tractor with Remote Cable Cylinder Control Valve:
1. Connecting Harness Wires. There are 4 wires that must be connected inside Tractor. 1. Red
Wire (power supply), 1 Black Wire (Ground) and 2 Brown Wires (Neutral Safety Switch). These will
have to be spliced into Tractor circuits. (See Figure 15).
2. Ground Wire. The Black
wire at the harness (See Figure
15) can be connected inside the
cab floor, or it can be run down
through the floor and connected
to the frame below the cab. If
grounding to the Cab floor con-
nect ground now.
3 Reinstall Dash Panel.
Reinstall the dash panel after
the wires have been connected
to the tractors wiring system
(See Figure 16 & 17) . The dash
panel is attached with screw on
fasteners. Note: All wires for the
trator connection with wire
harnes should all be under floor
mat of tractor and not visible.
this is a typical installation and
will vaey from type tractor to
tractor model.
"ON - OFF" Switch Installation
FIGURE 16 FIGURE 17