General information / installation requirements – Alamo Axtreme 02984405 User Manual
Page 25
© 2006 Alamo Group Inc.
Section 3 - 5
Axtreme Boom (Asy. Man) 07/06
WARNING:
Never operate the tractor with a loose wheel rim or disc. Always tighten nuts
to the specified torque and at the recommended intervals.
2. Extend front wheels out so that it is 55" inches between the inside of the tires. This will allow
no interference between tire and front mount bracket. FIGURE 2.
50"
55"
FIGURE 1
96"
FIGURE 2
TRACTOR PREPARATION (FIGURE 1 & 2)
1. Temporally remove ROPS and fenders from tractor axle. Move left rear tire out so that it is 50 inches
from the outside of left rear tire to the center of tractor. Then move the right rear tire out so that it is 96
inches between the outside of the left and right rear tires. Refer to your tractor’s Operator’s Manual for
instructions on Rear Wheel Adjustment for your particular tire. FIGURE 1. Hydraflate rear left tire as
much as needed for stability but stay in factory-recommend limit.
WARNING!
Use extreme care when moving, handling or adjusting the tractor tires. The tires are
extremely heavy and could fall and crush you
Q
Use an overhead crane or forklift to move the tires.
Q
Properly fasten the tires to the material handling equipment to prevent the tire
from falling.
WARNING!
The hydraulic oil is under high pressure and a hydrauli leak can cause oil to be injected
under the skin.
Q
Before starting the tractor ensure all hydraulic connections have bee tightened
Q
Never check for leaks with your hands. Use a piece of wood or cardboard to
check for the leak making sure your hands and face are kept away from the
leak area.
Q
Repair any leaks before operating the equipments
Q
Clean up all oil that has leaked according to the requirements of the oil supplier.
Oil residue on the ground can result in unjury from slipping or falling.
General Information / Installation Requirements