Alamo Axtreme 02984405 - Manual (Page 22)

© 2006 Alamo Group Inc. Section 3 - 2
Axtreme Boom (Asy. Man) 07/06
General Information:
The tools you will need at the assembly site are as follows:
1. Welding equipment (including correct head gear, eye shields, and protective clothing.)
2. Impact wrench or socket and ratchet set.
3. Rubber mallet.
4. Box-end, Allen, and crescent wrenches.
5. Alignment pins.
6. Phillips and plain-head screwdrivers.
7. Forklift or hydraulic floor jacks with rolling back boards.
8. Over head hoist and floor jacks
9. Jack Stands and/or other support devices that are strong enough to support tractor and components
10. Multidirectional Levels.
11. Paint Scraper.
12. Hydraulic Filter Buggy or Cart.
13. Safety shoes, safety glasses, and gloves.
14. A hard hat should be worn by anyone working under any raised component.
Remember to follow each step closely and cautiously. Be aware of all support personnel at all times.
Keep the assembly area as clean as possible; clean up all spills when they occur. An uncluttered assembly area
and a crew that is sensitive to the hazards involved in putting this implement together will help prevent accidents.
Keep all unauthorized personnel from the area. Do not allow children near the assembly site nor allow them on or
near the tractor after assembly. There is no safe place for anyone except the operator on the tractor and those
assisting with the assembly.
To help you assemble your new Unit and mount it to your tractor, a detailed assembly instruction
Manual is being provided with the mount kit to provide detailed instructions and part numbers. Please
consult this document for specific information. When needed, you can get additional information or
clarification from Your Dealer or Alamo Group Customer Service.
This publication provides general information and may not specifically be for your case or tractor, but,
in connection with the assembly drawings that are sent with the mount kit, this publication offers you some
valuable assistance - please read it thoroughly and use it with your assembly drawings and other
publications. Other publications may include, operators manual, parts manual, service manual or any other
publication sent by manufacturer. Keep all publications together for future reference.
These mount kits are made for selected tractors with standard configurations. Only the noted
options and tire sizes listed in the Mounting Specifications will work with these mount kits. Other options,
front axles, or different tire sizes may prevent the mount kit from fitting your nonstandard tractor. Alamo
Group cannot take responsibility for these problems or any modifications made to the unit.
Throughout these instructions, references are made to right or left directions. Right and left are
determined by sitting on the tractor seat and facing the direction of travel forward always.
This is the Safety-Alert symbol. When you see this symbol on your machine or in these
instructions, be alert to the potential for personal injury. Follow recommended precautions
and safe operating practices.
A signal word - DANGER, WARNING, or CAUTION - is used with the Safety Alert symbol.
DANGER identifies the most serious hazards.
General Information / Installation Requirements
DANGER!
DANGER!