Alamo Axtreme 02984405 - Manual (Page 56)

Axtreme Boom (Asy Man) 07/06
© 2006 Alamo Industrial
Section 6 - 8
Pump - Driveline - Hose Installation
Cylinder Diverter Valve Block
The Cylinder Diverter Valve Block is used
to control the hydraulic head swivel option if used.
The control block diverts the hydraulic pressure
through a bypass by using an electric solenoid so
the pressure can be used to operate two functions
(one at a time) as needed. This block is bolted to the
mainframe on the LH side back from left front wheel
and is connected to the door cylinder and the
optional head swivel option cylinder.
Through a toggle switch operation it can be
decided which cylinder will function when on the
cable control valve system and through button
trigger combination on the joystick (electronic valve
control) option. If the head swivel option is not used
this diverter valve will not be used. (See Figure 17,
18 & 19)
Used with Swivel Head Option Only
Figure 17
C4 Port this side
(Not Seen) to Door
Cyl Rod End
C1 Port this side
(Not Seen) to Door
Cyl Base End
C3 Port to Head
Swivel Cyl Rod End
C2 Port to Head
Swivel Cyl Base
End
These 2 threaded holes on back
side for mounting diverter valve
to frame (Not Seen)
Pi Pressure from control Valve
Door / Head Swivel of control
valve Port
These 4 holes are through holes
that would be used if this were a
stacking valve to stack two (or
more) valves together. These holes
are not used in this application.
P2 Port Return to control valve Door
. Head Swivel Port of control valve.
Electric Solenoid
Electric Solenoid Retaining Nut
2
3
1
FIGURE 18
Diverter Valve