PASCO ME-8950A COMPLETE ROTATIONAL SYSTEM - Manual (Page 6)

Complete Rotational System 012-05293F
2
Equipment
50g masses (2)
100g mass with 3 open
hooks
center post
side post
plastic
indicator disk spring
ME-8952 Centripetal Force Accessory Equipment
The ME-8952 Centripetal Force Accessory includes:
- center post that supports an indicator mechanism
which consists of a small pulley, a movable spring
holder, a movable indicator, a spring, and a plastic
indicator disk
- side post for hanging hooked mass
- mass (100 g) with 3 open hooks
- 2 additional 50 gram masses
- clamp-on pulley
- 1 spool of thread
300g square mass (2)
with thumbscrews and
square nuts
low-profile thumb-
screw assemblies (2)
aluminum rotating
platform
cast iron "A" base
"E" rings (2, 1 extra)
rotating vertical shaft
with 10-hole pulley
accessory
mounting rod
ME-8951 Rotating Platform Equipment
The ME-8951 Rotating Platform includes the follow-
ing:
- PASCO cast iron “A” base with rotating shaft and
pulley with 10 holes
- aluminum track
- two square masses (about 300 g) with thumb screw
and square nut
- two additional low-profile screws and square nuts
to act as stops for the square mass in the Conser-
vation of Angular Momentum experiment
- accessory mounting rod for mounting a 10-spoke
pulley with or without the optional PASCO Pho-
togate Head
- photogate mounting rod for mounting a PASCO
Photogate Head (ME-9498A)
clamp-on
pulley
spool of thread
photogate
mounting rod