PASCO OS-8539 Educational Spectrophotometer User Manual
PASCO Equipment
This manual is related to the following products:
Table of contents
Document Outline
- 012-06575C_quick start.pdf
- thumbscrew
- three-step pulley
- Rotary Motion Sensor
- rod clamp
- Quick Start 1: Prepare Rotary Motion Sensor
- Remove the Pinion
- Rotate the hinge.
- Remove the thumbscrews.
- Spectrophotometer Base
- Quick Start 2: Prepare the Hinge
- Rotary Motion Sensor
- Use the thumbscrews to attach the sensor.
- Put the Pinion on the shaft.
- hinge
- Spectrophotometer Base
- Quick Start 3: Attach the Sensor and Pinion
- lock washer
- Degree Plate
- Light Sensor Arm
- Grating Mount
- Light Sensor Mount with Aperture Disk and Screen
- Light Sensor
- threaded post
- wing nut
- Focusing Lens
- Quick Start 4: Degree Plate & Light Sensor Arm, Grating Mount, Focusing Lens, Light Sensor Mount, and Light Sensor
- light source
- Quick Start 5: Put Base onto Optics Bench
- light ray path
- Quick Start
- Optics Bench
- Collimating Lens
- Quick Start 6: Setup for Collimation
- Quick Start 7: Attach the Grating
- Scan slowly and continuously in one direction.
- 012-06575C_text.pdf
- Grating Mount
- Grating
- Degree Plate
- Light Sensor Arm
- Spectrophotometer Base
- Collimating Slits
- Collimating Lens
- Pinion*
- Cuvettes (2)
- Focusing Lens
- Rod Mounting Clamps (2)
- Line up the edge of the Grating Mount with the zero line.
- Central ray (“zeroth order”
- Introduction
- Description
- ml = d sin q, m = 0, 1, 2…
- Set Up
- Ratio of Radii = _______
- Procedures
- 012-06575C_exp.pdf