Diamond Products SL - Manual (Page 25)

5 Sawing
5.1 Before sawing
•
check if all screws are fastened tightly
•
control rope tension and if necessary
readjust (A) with the crank (3)
5.2 Sawing, hydraulic
Hydraulic drive
Switching water on
•
Open water cock at drive unit
Switch on drive unit
•
Set all valves to position "0"
•
Start drive unit (see Operating Manual of
drive unit)
Select level
•
With multi-level drive units, select the pro-
per level
(see "Selecting drive unit and sawing mo-
tor ”, chapter 3.2.)
Switch on rope drive
•
Set main valve at the drive unit to position
"I"
The rope will now be moving (C)
Switch on forward feed (B)
Increase forward feed pressure up to...
... main pressure: 100...150 bar
Fig. vors1.tif
SL Sawing
sl9806e page 25