Diamond Products SL - Manual (Page 11)

2.5 Function with hydraulic drive
Hydraulic drive
2.5.1 Guiding and tightening of rope
The rope is being guided by ...
– the drive wheel (2)
– two central deflection pulleys - top and
bottom (5 and 8),
– two deflection pulleys top and bottom
(9 and 14),
– and by the guiding reels top and bot-
tom (10 and 13).
The rope is being tightened by ...
> turning the tension spindle (3) clockwise,
> by which the swivel rack (4) tilts outward
> and the diamond sawing rope is being
tightened across the drive wheel (2)
2.5.2 Circular motion /Forward feed,
hydraulic
The movable portion of the system turns around
the center tube (12), when...
> the connected forward feed circuit at the dri-
ve unit is being opened,
> the hydraulic forward feed motor (6) will turn
> and through the transmission gear in front of
the feed motor
> will drive the cogwheel (on the feed transmis-
sion gear)
> which engages with the gearwheel circumfe-
rence at the support.
2.5.3 Rope drive, hydraulic
> When the Main circuit of the drive unit is
opened,
> the sawing motor (1) will turn and will drive
> the drive wheel (2) and thereby
> will drive the rope.
The speed of the rope is determined by...
1) ... the oil flow from the drive unit
2) ...flow intake of the sawing motor
(controllable)
2.5.4 Emergency Stop
The system can only be stop-
ped at the drive unit. Observe
also the Operating Manual of
the drive unit.
SL Technical Data
sl9806e page 11