Diamond Products SL - Manual (Page 12)

2.6 Funktion electric drive
Electric drive
2.6.1 Guiding and tightening of rope
The rope is being guided by ...
– the drive wheel (2)
– two central deflection pulleys - top and
bottom (5 and 8),
– two deflection pulleys top and bottom
(9 and 14),
– and by the guiding reels top and bot-
tom (10 and 13).
The rope is being tightened by ...
> turning the tension spindle (3) clockwise,
> by which the swivel rack (4) tilts outward
>and the diamond sawing rope is being
tightened across the drive wheel (2)
2.6.2 Circular motion/Forward feed,
electric
The movable portion of the system turns around
the center tube (12), when...
> the connected forward feed is switched on
at the electric control,
> the electric feed motor (6) runs
> and through the transmission gear (in front
of the feed motor)
> drives the cogwheel (at the feed transmissi-
on gear)
> which engages with the gearwheel circumfe-
rence at the support
2.6.3 Rope drive, electric
> When the main drive unit is switched on at
the electric control,
> the electric sawing motor (1) will run
> and drive the drive wheel (2)
> and thereby the rope.
The speed of the rope is determined by...
1) ...the number of revolutions of the
electric drive motor (not controllable)
2) ...the diameter of the drive wheel
(not controllable)
2.6.4 Emergency Stop
The system can only be stop-
ped at the electric control unit.
Observe also the Operating Ma-
nual of the electric control unit.
Technical Data SL
page 12 sl9806e