Diamond Products SL - Manual (Page 15)

3.2 Select drive unit and sawing
motor (hydraulic)
Hydraulic drive
Through correct selection of drive unit, power
level (in case of multi-level drive units) and
Sawing motor the correct cutting speed will be
obtained, hence:
– optimum sawing performance
– best endurance of rope
– few rope ruptures
3.2.1 Specifics for the use of the "profi
disk"
The effective diameter of the drive wheel mea-
sures 180mm (~7-5/64”). Therefore:
•
Set the mark Ø 180 onto
the range SK-SD (1:1) and ...
•
... depending on output rate of drive unit
read out the correct sawing motor.
3.2.2 Drive units
Multi-level drive units: Use Level II or higher.
When hitting upon reinforcement steel rods one
can then switch down.
Work only with the designated drive units
and only on the recommended levels
(base: v = 20...30 m/s (~22...33 yards/se-
cond))
BR-3
(I)
DK
(I)
CR-3
(I)
BR-4
CR-3
(II)
DK
(II)
BR-3
(II)
AD-S2
AD-S3 (I)
BL-S
CR-L
DK
(III)
CR-3 (III)
AD-S3 (II)
26 l/min 30 l/min 33 l/min 40 l/min 42 l/min 45 l/min 47 l/min 50 l/min
11 ccm 22
m/s 26 m/s 28 m/s 34 m/s - - - -
16 ccm - - - 24 m/s 24 m/s 26 m/s 28 m/s 29 m/s
18 ccm - - - 21 m/s 22 m/s 24 m/s 25 m/s 26 m/s
Fig.drehztab.tif
SL Preparation for work
sl9806e page 15