Diamond Products CB66DS - Manual (Page 29)

H30 Operation Manual Houston Street Technologies
9
5. Quick Start Guidelines
POWER UP
When the power button is pressed the H30 will display a splash screen that will show a company logo and
controller information. After the splash screen has timed out and if START UP SECURITY is not enabled, the
Operation Screen will be displayed. If START UP SECURITY is enabled, a 4-digit PIN is required to access the
functionality of the controller.
CONTROLLER SETUP
The Main Menu can be accessed by pressing and releasing the ENTER button while at the Operation Screen. All
other sub menus can be accessed from the Main Menu.
See detailed controller setup instructions in the following sections of this manual.
ENGINE START UP
While at the Operation Screen the engine can be started by pressing and holding the ENTER button. The engine
can only be started from the Operation Screen.
NOTE: The H30 protects the engine starter from damage by limiting the time that the operator can crank the
engine to 15 seconds with a 30 second rest between cranks.
When used with an electronically controlled engine, the engine ECU may be programmed to use a cold start
aid (block heater, air intake heater, glow plugs, etc.), a notice will be displayed informing the user that an engine
preheat is taking place and to wait for the preheat operation to complete before attempting to start the engine.
If the ECU COMMUNICATION ERROR is flashing on the H30 screen, the engine will not start.
ENGINE CONTROL
While the engine is running and the H30 is displaying the Operation Screen, the UP and DOWN buttons will
increase and decrease the engine speed, respectively. The manner in which the speed increases or decreases
depends on the current Operation Mode: MANUAL RAMP, MANUAL STEP or AUTO RAMP (MANUAL
RAMP is the default Operating Mode).
ENGINE SHUTDOWN
When the power button is pressed while the engine is running, the engine will shutdown immediately.
CAUTION: Always follow engine manufacturer recommendations for controlled engine shutdowns prior
to pressing the power button.
If operating conditions cause the engine ECU to derate or shutdown the engine, the controller’s red LED will
flash and the engine will derate or shutdown based on the engine ECU’s programming.