Magnum Venus Plastech UltraMAX UPLS-2300_UPLS-2300-SS - Manual (Page 35)

MAINTAINENCE AND REPAIR MANUAL
UPLS-2400-SS/2300-SS
MAGNUM VENUS PLASTECH REV 1.13
APRIL 2010 PAGE 35
When using the Cup style seals there are 2 ways to configure them in the assembly.
•
Standard Piston Cup configuration. Both Cups facing the same direction.
•
Optional Piston Cup configuration. Cups facing opposing directions.
•
Barrel type seal.
CUP STYLE SEAL INSTALLATION
•
Note: If the Fluid Section is to be used with a Polyester/Vinylester resin system then a liberal coat
of Red Grease should be applied to the Piston Cups before installing on to the Piston Body. The
Piston Cups on an Epoxy or Urethane system should be clean and in good condition with no
lubricant or grease. If in doubt contact the material manufacturer for recommendations.
STANDARD CONFIGURATION Reference (FIG 5.50) for stack configuration.
Place the Piston Cup Backup down over the Piston Body. Install with the ridges up.
Place the first Piston Cup down over the Piston Body facing up.
Place the Piston Cup Spacer over the Piston body, the small end of the Piston Cup Spacer should go
down inside the Piston Cup that is in place and the ridges on the Piston Cup Spacer should be facing up.
Place the second Piston Cup down over the Piston Body facing up, same orientation as the first.
Place the Piston Cup Compression ring over the Piston Body.
FIG 5.50