Magnum Venus Plastech ULTRABOND 10:1 ADHESIVE UNIT - Manual (Page 27)

UltraBond 10:1 Operations Manual
Rev. 12/2012 Page | 27
NOTE: Allow time for air to be pushed out of the air bleed off valve at the top of the barrel piston.
9.
Once barrel piston has come to a complete stop and a small amount of activator starts to come out
the bleed off valve close the bleed off ball valve (see figure 27).
10.
Remove mixer or night cap from the front of dispensing block / gun (see fig. 28 & 29), if this is not
already done.
fig. 28 fig. 29
11.
Position dispensing block / gun over an appropriate waste container to allow priming of lines (see fig. 30)
fig. 30
12.
Fully open the dispensing head / pull trigger on the gun.
13.
Slowly turn up pump pressure on Activator ram pump to 20 psi (1.2 bar) (see figure 31).
Fig. 31