beautypg.com

Magnum Venus Plastech ULTRABOND 10:1 ADHESIVE UNIT User Manual

Page 25

background image

UltraBond 10:1 Operations Manual

Rev. 12/2012

Page | 25

20. Allow unit to run until a steady flow of adhesive material is being dispensed out of the dispensing

block with no air pockets.


21. Push the dispensing head handle to the close position.

22. Flush the dispensing head.

23. Leave ram control lever in “down” position

Priming of Activator Ram Transfer Pump


1.

Pin the main activator pump to the appropriate ratio position on the slave arms of the adhesive
pump (see figure 24).

Fig. 24

2.

Fill solvent cups with throat seal liquid (see figure 25)

Fig. 25