Liquid Controls SP2200 - Manual (Page 18)

16
REMARKS DISPLAY PRESS
PRGM
PRGM
PRGM
PRGM
PRGM
STEP
5
SETTING
THE
RELAYS
ENTER
ENTER
factor
count
rate
loc
relay
a tot
or
a rate
tot a
or
tot c
du ##.#
hy ##.#
rate a
or
rate c
hy ##.#
ENTER
ENTER
ENTER
ENTER
This section sets up the relay information.
Press the PRGM key to choose A TOT (A
relay assigned to total) or A RATE (A relay
assigned to rate). Press enter when the de-
sired choice is displayed.
This section will only appear if a tot is se-
lected. Press the PRG button to choose tot
a or tot c. Press the ENTER key to enter the
displayed choice
Set relay duration .1 to 99.9 sec.
Counter autoresets and relay is energized
for selected time. If 00.0 is selected counter
does not autoreset. Output is active if counter
is equal or above preset.
This is the hysteresis setpoint
for relay A (00.0 to 99.9). This section will
only appear if
tot c is selected.
This section will only appear if a rate is
selected. Press the PRG. button to choose
rate a or rate c. Press the ENTER key to
enter the displayed choice.
This is the hysteresis setpoint
for relay A (00.0 to 99.9).