Liquid Controls SP2200 - Manual (Page 17)

15
DISPLAY REMARKS
factor
count
rate
loc
LC PG
or
LC ALL
CoDE
Flashes
followed by:
#####
CoDE
Flashes
followed by:
0
LoC
or
uN LoC
PRGM
PRGM
PRGM
PRGM
This section of the menu is used to set up
the lockout type and code.
LC PG = Locks program but presets and
reset are accessible.
LC ALL= Locks entire keypad.
Press the PRGM button to toggle between
choices; Press ENTER to enter displayed
choice.
After CODE flashes the display will show the
existing lock code. To change the code press
the key under each digit to be changed. Press
ENTER to enter displayed value.
When in the run mode press LOCK. After
CODE goes out, key in the lock code (see
programming step 4) by pressing the keys
under the digits to be changed. Press the
ENTER key to enter the displayed code.
After the code is entered the unit will display
LOC (unit is locked) or UN LOC (unit is un-
locked). This message will be displayed for
approximately 3 seconds before the unit re-
turns to the run mode.
ENTER
ENTER
LOCK
AND
UNLOCK
UNIT
ENTER
PRESS
SETTING
LOCK
STEP
4
PRESS
LOCK