Liquid Controls SP2850 (MS-649) - Manual (Page 16)

Sponsler, Inc. Model SP2850-TC with MS649 Page 16 DOC#: MN-2850
(Press D to display desired timebase)
ENT (selects displayed options) K-FACTOR (Flashes, followed by existing K-Factor)
CLR 0 Flashes
1 1 D 6 8 (as an example) 11.68 Flashes
(Press D for decimal)
ENT RUN MODE
Setting 16 Point Option for Non-linear Input: Reference `16 Point Linearization Option”
NOTE:
If TEST is entered, point data can be entered exactly as in selected time entries. However, when the unit
`runs’ in Test Mode `K-Factor’ is always 1. `Rate’ (R) displays frequency (inputs per sec.). Counter displays 1 count
per each input.
Press Display
D MENU Flashes then PRESET
↓
D until 16POINT
↓
ENT LN
↓ 16PT↓ (LN: Linear 16PT: 16 point)
(Press D for 16 point)
ENT MINUTES
↓
D HOURS
↓
D TEST
↓
D SECONDS
↓
(Press D to go to minutes)
ENT (selects displayed option) POINT 00 (Enter point 00 to go to run mode)
1 (selects point 1) POINT 01 (Key in point desired)
ENT F # # (Shows frequency in memory)
CLR F 0
1 0 0 (as an example) F 100 (Frequency for point 1 is 100)
ENT K # # (Shows K-Factor in memory)
CLR K 0
1 0 0 (as an example) K 100 (K-Factor for point 1 is 100)
2 POINT 02 (Enter point data as desired)
(Repeat through 16 points)
CLR POINT 00 (Enter point 00 to exit setup)
ENT RUN MODE