Liquid Controls DMS Office - Manual (Page 5)

5
LectroCount Data Management System
LC software is copyright protected and may not be duplicated
under any circumstances without authorization from Liquid
Controls. Be sure to review the software license agreement
on page 3.
A vehicle delivery system typically includes the following
components:
Metering System
The metering system is typically mounted to the back
or side of a delivery vehicle to measure the product
being delivered. Components of this system can
include the meter, electronic register, strainer, air
eliminator, and control valve.
DMS Module
The DMS Module provides connections for the printer,
the DMS Lap Pad, electronic registers, and a USB
flash memory device. It is powered by the vehicle’s
battery and accessory circuit. It can be mounted to
support brackets in the cab of the vehicle. These
support brackets are supplied with each unit.
DMS Lap Pad
The DMS Lap Pad is the user interface device. It is
used for initial set up, calibration of the system, data
collection and delivery execution.
Printer
The printer prints out a record of the delivery. This
ticket is typically a multi-layer ticket so one copy may
be left with the customer and one retained for physical
record of the delivery.
USb Flash Memory Device
The USB flash memory device is a data repository
used to transfer data between the DMS Module and
the office computer.
DMS office Software
DMS Office is a data capture program that serves
as the bridge between the DMS Module and your
company’s back office software. It also configures
ticket printouts and driver information.
Epson Slip Printer
M-10 Meter with LectroCount LCR-II Electronic
Register, Optical Air Eliminator, High Capacity Strainer,
and E-7 Valve.
DMS Lap Pad
Support Brackets
DMS Module
DMS Office Software USB Flash Memory
Device