Controlled Products Systems Group 212ILW - Manual (Page 7)

212iLW/242iLW Standalone Keypad
Installation/Programming Manual
Document # 6050700, Rev. 1.1, D2d
7
4. Mounting
The keypad is designed to be flush mounted using a standard single-
gang electrical box. In addition, it can be flush mounted directly to
the wall surface by cutting a hole in the wall. To properly size the
mounting and wire access hole, use the installation template on the
last page in this manual and on the unit’s container.
Mounting height can vary depending on requirements. An
appropriate range is typically between 48 and 52 inches on center off
the floor.
For outdoor installations, use a weatherproof backbox and seal the
wire entry locations with silicone and provide a drain hole. In
addition, use the anti-oxidant grease pack for the wire harness
connectors.
Figure 3 Keypad Mounting Height