Controlled Products Systems Group 212ILW - Manual (Page 26)

212iLW/242iLW Standalone Keypad
Installation/Programming Manual
Document # 6050700, Rev. 1.1, D2d
26
9. Wire Harness Loopback
Connections
If the Master Code is either not working or forgotten, power down the
system, connect the wire harness as shown in Figure 12 below, and
then power the system up again. The unit should now be in program
mode. Next, change your Master Code using the programming
command and power down the system and restore the wire harness
to its original configuration and power the system back up.
Figure 12 Program Mode Loopback