Controlled Products Systems Group WKP5LM3 - Manual

1 2 3
4 5 6
7 8 9
* 0 #
Cancel
Carton Inventory
Overview
The Wireless Keypad uses a digitally secure intercom
link that allows it to control up to four access points.
The Wireless Keypad is compatible with various
Liftmaster Wireless Products.
Model WKP5LM can hold up to 5 PIN Numbers.
Model WKP250LM can hold up to 250 PIN Numbers.
Assembly
Install 4 AA Alkaline batteries (not provided). (Lithium
batteries recommended for colder environments.)
Keypad will beep.
Keypad will continuously beep indicating no Master
PIN Number has been programmed. Proceed to
Initial Setup.
1
Keypad
Models WKP5LM & WKP250LM
Wireless Keypad
Initial Setup
Step 1: On keypad press:
Step 2: Enter 4 digit Master PIN Number.
Example: 1234.
Multiple Keypads at Same Location
Step 1: On secondary Keypad enter Master PIN
Number:
Step 2: Then: 5 6
NOTE: To switch a secondary Keypad to a Main
Keypad, enter the Master PIN Number followed by
“57”.
Step 3: On Main Keypad enter Master PIN Number:
Step 4: Then: 0 5
NOTE: If a siren noise is heard the programming has
failed. Repeat process.
NOTE: This step applies only if more than one
Keypad is being used.
Bolt (4)
Washer (4)
Nut (4)
Screw (4)
Allen Wrench
®
NOTE: “ * “ is the cancel button that will cancel any
call or key sequence.
The Keypad can be used as a primary or secondary
device. Accessories should be programmed directly to
the primary device.
If programming to a GCU, see page 2.
If programming to an ULTRX900R, see page 3.
If programming to a GAPLM, see page 4.
If programming to existing receiver, see page 4.