Testing the keypad – Controlled Products Systems Group 212ILW User Manual
Page 15

212iLW/242iLW Standalone Keypad
Installation/Programming Manual
Document # 6050700, Rev. 1.1, D2d
15
6. Testing the Keypad
After installing the keypad, IEI recommends that you perform the
keypad self-test once a year, to ensure that the keypad works
properly.
1. To perform the self-test, with the unit powered up, press the
following keys on the keypad: 7890#123456*
• If all 12 keypresses are accepted, the keypad enters self-test
mode.
• The LEDs alternate green, yellow, and red followed by the
sounder beeping three times.
2. Verify that the master code works correctly. (The master code
accesses program mode and activates the main relay to verify
that the locking device is working.)
The default master code is 1234.
(If the default is not working, refer to section 9.)