CTI Products TurboVUi Dispatch Client Software - Manual (Page 31)

TurboVUi Dispatch Software Installation and Configuration Guide
31
A UDIO P RESETS
While in Edit mode, options are available that will customize the way in which audio will be transmitted and received.
Click on the
Options menu, click Audio Presets , and then click Config to display the following window.
Click the button to save all Audio Configuration settings.
General tab
Use this tab to configure audio parameters such as Muting, Intercom, and Audio Quality.
Mute Audio When Transmitting
Select this option if the Dispatcher is making a voice call, and the audio is being received on another
nearby radio, making it difficult to continue the call because of a lag in the repeated audio.
Mute audio streams from radios connected to a Gateway
Select this option if bothersome audio transmissions are being received by another radio resource
connected to the TurboVUi Dispatch client. This is also referred to as “RF Cross Muting”.
Enable PC Cross Mute
Select this option to mute audio from adjacent PCs. Adjacent PCs should have the same Cross Mute
ID selected. This is also referred to as “Audio Cross Muting”.
Intercom Audio uses select/unselect device and speaker
Select this option to direct received Intercom Audio to same devices configured for Select and Unselect
volume. If this option is not enabled, then received Intercom Audio will be directed to device chosen
for the
Intercom Out parameter located in the Devices tab.
Intercom Audio uses select/unselect volume
Select this option to modify the volume level set for the Intercom Volume parameter located in the
Devices tab based on whether the receiving radio is Selected or Unselected.
Intercom Audio uses radio talk group volume
Select this option to modify the volume level set for the Intercom Volume parameter located in the
Devices tab based on the volume level set in the Radio Controller for a particular talk group.
Audio Quality
Compressed Mode (2.2kBytes/s per client user and Talk Group) should be used when either:
a TurboVUi client is connected to the IP Gateway(s) using a WAN such as the Internet, or
there is a concern that “High Quality” mode will use too much bandwidth.
High Quality Mode (22kBytes/s per client and Talk Group) should be used when:
Note: The configuration file for
Audio Settings can be located and
viewed by clicking on the file name
“AudioSettings.cfg”