CNB SFM-21VF - Manual (Page 7)

DIP Switch Setup
Camera ID Setup
Switch State
Protocol P0
(Pin 1)
P1
(Pin 2)
P2
(Pin 3)
OFF OFF OFF PELCO-D, 2400 bps
ON OFF OFF PELCO-D, 9600 bps
OFF ON OFF PELCO-P, 4800 bps
ON ON OFF PELCO-P, 9600 bps
OFF OFF ON SAMS.. , 4800 bps
ON OFF ON PANA.. , 9600 bps
◎ Select the appropriate Protocol with DIP switch combination.
Communication Protocol Setup
◎ If you want to control using DVR or P/T controller, their protocol must be identical to
camera. Otherwise, you can not control the camera.
◎ If you changed camera protocol by changing DIP S/W, the change will be effective
after you reboot the camera.
◎ Factory default of protocol is “Pelco-D, 2400 bps”.
◎ If you want to information using protocol setup, download is possible form CNB home
page.
- DOWNLOAD http://www.cnbtec.com/en/html/down/data_down.php
Pin 1 2 3 4 5 6 7 8
ID Value 1 2 4 8 16 32 64 128
ex) ID=5 on off on off off off off off
ex) ID=10 off on off on off off off off
◎ ID number of camera is set using dip switch. The example
is shown bellow.
◎ The range of ID is 1~255. Do not use 0 as camera ID. Factory default of
Camera ID is 1.
◎ If you want to control a certain camera, you must match the camera ID with Cam
ID setting of DVR or Controller.
ON OFF ON PANA.. , 9600 bps
OFF ON ON Bosch , 9600 bps
ON ON ON SAMS.TW, 9600 bps
10 11