CNB SFM-21VF - Manual (Page 15)

◎ Function : The group function allows running sequence of Presets, Pattern and/or
Swings. Max 8 group can be stored. Each group can have max 20 action
entities which can be preset, pattern or swing. Preset speed can be set up
and the repeat number of Pattern & Swing can be set up in Group setup.
Dwell time between actions can be set up also.
◎ Set : Use OSD menu to create a Group.
Preset 1 Pattern 1 Swing 1
DWELL TIME
Max. 20 Action
GROUP Other Functions
◎ Power Up Action This function enables to resume the last action executed before
power down. Most of actions such as Preset, Pattern, Swing and
Group are available for this function but Jog actions are not
available to resume.
◎ Auto Flip In case that tilt angle arrives at the top of tilt orbit(90° ), the
camera pans 180°to keep tracing targets. If this function is
OFF, tilt movement range is 0 ~ 95° .
◎ Parking Action This function enables to locate the camera to specific position
automatically if operator doesn’t operate the controller for a
while. The Park Time can be defined as an interval from 1
minute to 4 hours.
◎ Alarm Input 4 Alarm Inputs are used. If an external sensor is activated,
◎ Run : Method 1) Run Pattern [Group NO.+20] ex) Run Group 7 : Run Pattern [27]
Method 2) Go Preset [Group NO.+150] ex) Run Group 7 : Go Preset [157]
◎ Delete : To delete Group, use OSD menu.
◎ Alarm Input 4 Alarm Inputs are used. If an external sensor is activated,
camera can be set to move to corresponding preset position.
It is noted that the latest alarm input is effective if multiple
sensors are activated.
◎ GLOBAL/LOCAL
Image Setup
WB(White Balance) and AE(Auto Exposure) can be set up
independently for each preset. There are 2 modes, "Global"
mode & "Local" mode. The Global mode means that WB or AE
can be set up totally and simultaneously for all presets in "ZOOM
CAMERA SETUP" menu. The Local mode means that WB or AE
can be set up independently or separately for each preset in
each preset setup menu. Each Local WB/AE value should
activate correspondingly when camera arrives at each preset
location.
During jog operation, Global WB/AE value should be applied. All
Local WB/AE value do not change although Global WB/AE value
changes.
26 27