CNB SFM-21VF - Manual (Page 14)

◎ Function Max. 127 positions can be stored as Preset position. The Preset
number can be assigned from 1 to 128, but 95 is reserved for starting
OSD menu.
Camera characteristics (i.e. White Balance, Auto Exposure) can be set
up independently for each preset. Label should be blank and "Camera
Adjust" should be set to "GLOBAL" as default. All characteristics can
be set up in OSD menu.
◎ Set Preset [1~128]
◎ Run Preset [1~128]
◎ Delete Preset To delete Preset, use OSD menu.
◎ Run Swing Method 1) [Swing NO.+10]
Method 2) [Swing NO + 140]
ex) Run Swing 3 : [13]
ex) Run Swing 3 : [143]
◎ Delete Swing To delete Swing, use OSD menu.
◎ Function : Pattern Function is that a camera memorizes the path (mostly curve path)
by joystick of controller for assigned time and revives the path exactly as it
memorized. 4 Patterns are available and Maximum 1200 communication
commands can be stored in a pattern.
PRESET
SWING
PATTERN
◎ Function By using Swing function, you can make camera to move between 2
Preset positions repeatedly. When swing function runs, camera moves
from the preset assigned as the 1st point to the preset assigned as the
2nd point in CW(Clockwise) direction. Then camera moves from the
preset assigned as the 2nd point to the preset assigned as the 1st point in
CCW(Counterclockwise) direction.
In case that the preset assigned as the 1st point is same as the preset
assigned as the 2nd point, camera turns on its axis by 360° in CW
(Clockwise) direction and then it turns on its axis by 360° in CCW
(Counterclockwise) direction. Speed can be set up from 1°/sec to
180°/sec.
◎ Set Swing To set Swing, use OSD menu.
◎ Setting : Pattern can be created by one of following two methods.
Method 1) [Pattern NO.]
- Pattern editing screen is displayed as bellow.
- Movement by Joystick and preset movement
can be memorized in a pattern.
- The rest memory size is displayed in progress bar.
- To save the recording, press NEAR key and to
cancel, press FAR key.
Method 2) OSD using OSD menu: See the section “How to use OSD menu”.
◎ Run : Method 1) Run Pattern [Pattern NO.] ex) Run Pattern 2 : Run Pattern [2]
Method 2) Go Preset [Preset NO.+130] ex) Run Pattern 2 : Go Preset [132]
◎ Delete : To delete Pattern, use OSD menu.
SWING
24 25