CNB SFM-21VF - Manual (Page 18)

MOTION SETUP PARKING ACTION SETUP
◎ Setup the general functions of Pan/Tilt motions.
• MOTION LOCK [ON/OFF]
- If Motion Lock is set to ON, it is impossible to set up
and delete Preset, Swing, Pattern and Group. It is
possible only to run those functions. To set up and
delete those functions, enter into OSD menu.
• PWR UP ACTION [ON/OFF]
- Refer to “Other Functions" section.
• AUTO FLIP [ON/OFF]
- Refer to “Other Functions" section.
◎ If Park Enable is set to ON, camera runs assigned
function automatically if there is no PTZ command
during assigned "Wait Time".
• PARK ENABLE [ON/OFF]
• WAIT TIME [1 minute ~ 4 hour]
- The time is displayed with "hh:mm:ss" format and
you can change this by 1 min unit.
• PARK ACTION
[HOME/PRESET/PATTERN/SWING/GROUP]
- HOME
Camera moves to home position if there is no PTZ
command during assigned "Wait Time".
• JOG MAX SPEED [1°/sec ~360°/sec]
- Sets maximum jog speed. Jog speed is inversely
proportional to zoom magnification. As zoom
magnification goes up, pan/tilt speed goes down.
• JOG DIRECTION [INVERSE/NORMAL]
- If you set this to ‘Inverse’, the view in the screen is
moving same direction with jog tilting. If ‘Normal’ is
selected, the view in the screen is moving reversely.
• TILT ANGLE [ON/OFF]
- If “TILT ANGLE” function is “ON”, Tilt start position is
5 degree.
command during assigned "Wait Time".
ALARM INPUT SETUP
◎ Match the Alarm sensor input to one of Preset
positions. If an external sensor is activated,
camera will move to corresponding preset position
when this item is predefined.
• ALARMx TYPE
[Normal OPEN/Normal CLOSE]
- Sets sensor input type.
• ALARMx ACT
[NOT USED/PRESET 1~128]
- Assign counteraction Preset position to each
Alarm input.
32 33