Swing setup, Pattern setup, Edit pattern – CNB SFM-21VF User Manual
Page 20
SWING SETUP
◎ SWING NO
[1~8]
Selects Swing number to edit.
If a selected Swing has not defined,
"NOT USED" is displayed in 1st
Position and 2nd Position
◎ 1ST POS.
◎ 2ND POS.
[PRESET 1~128]
Set up the 2 position for Swing function.
If a selected preset is not defined,
"UNDEFINED" will be displayed as
shown below.
SWING SETUP
SWING NO .
1
PATTERN SETUP
◎ PATTERN NO
[1~4 ]
Selects Pattern number to edit.
If a selected pattern number is
not defined, "UNDEFINED" will
be displayed under selected
pattern number.
◎ CLR PATTERN
[CANCEL/OK]
Deletes data in current pattern
◎ EDIT PATTERN Starts editing pattern.
EDIT PATTERN
◎ SWING SPEED
[1°/sec ~180°/sec]
Sets Swing speed from 1°/sec to 180°/sec.
◎ CLEAR SWING
[CANCEL/OK]
Deletes current Swing data.
When swing function runs, camera moves from the preset
assigned as the 1st point to the preset assigned as the 2nd point
in CW(Clockwise) direction. Then camera moves from the preset
assigned as the 2nd point to the preset assigned as the 1st point
in CCW(Counterclockwise) direction. In case that the preset
assigned as the 1st point is same as the preset assigned as the
2nd point, camera turns on its axis by 360° in CW direction and
then it turns on its axis by 360° in CCW direction.
SWING NO .
2ND POS .
1
PRESET 5
NOT USED
1ST POS .
☞
UNDEFINED
NEAR
◎ By using Joystick, move to start position with appropriate zoom. To start pattern
recording, press NEAR key. To exit this menu, press FAR key.
◎ Move camera with joystick of controller or run preset function to memorize the path
(mostly curve path) in a selected pattern. The total memory size and the rest memory
size is displayed in the form of bar. Maximum 1200 communication commands can be
stored in a pattern.
◎ To save data and exit, press NEAR key. To cancel recording and delete record data,
press FAR key.
36
37