First time configuration of the unit, First time configuration of the unit -12, Network connection -12 front panel -12 – Clear-Com VOICE2 User Manual
Page 32
Vitec Group Communications
VoICE IP Interface User Manual
2 - 1 2
15. Click the OK button on the Internet Protocol TCP/IP Settings
window.
16. Click the OK button on the Local Area Connection Properties
window.
17. Click the Close button on the Local Area Connection Status
window.
18. Close the Network Connections window by clicking on the X in
the top right hand corner.
FIRST TIME CONFIGURATION OF THE UNIT
Note that this process will need to be done with each of the new units
that need to be configured.
1. Connect one end of an Ethernet patch cord to the unit (Lan2
connector) and the other end to the Hub/Switch. Look out for (and
avoid) connections called ‘uplink’ on your hub/switch – these are for
connecting to another Hub/Switch.
2. Connect one end of an Ethernet patch cord to your PC’s Ethernet
interface and the other end to the Hub/Switch.
Figure 2-19: Network Connection
3. Connect the power to your Hub/Switch.
4. If the unit does not power up immediately press the power button
momentarily on the front panel – the power light should illuminate.
Figure 2-20: Front Panel
5. Power up your PC
6. Wait 60 seconds for the unit to start.