Clear-Com Eclipse-PiCo - Manual (Page 55)

Clear-Com Communication Systems
Eclipse PiCo Matrix Instruction Manual 4 - 1 7
WIRING TO A COMPUTER
The 3.5 mm connector on the PiCo unit’s front panel connects the
Eclipse PiCo matrix to an external computer. This connector is labeled
“RS-232.”
To connect a computer to the matrix, run cable from the PiCo’s
“RS-232” connector to the PC’s serial port. The maximum
recommended length of the cable is approximately 10 feet (3 meters).
Figure 4-14: Pinout for cable to connect PiCo matrix to external computer
pc connection (9-pin f) pico connection (3.5 mm jack)
1 N/C
2 tip
3 ring
4 N/C
5 screen
6 N/C
7 N/C
8 N/C
9 N/C