Clear-Com Eclipse-PiCo - Manual (Page 50)

Clear-Com Communication Systems
Eclipse PiCo Matrix Instruction Manual
4 - 1 2
Figure 4-9: Rear View of IMF-3 Frame
To External Device
To connect external devices to the RLY-6 interface, use the two DB-9M
connectors on the rear cable assembly panel for the interface. Figure
4-10 shows the pin assignment of these connectors as viewed from
the matrix side of the connector.
If a DB-9F is plugged into the connector labeled CH. A I/O, relays 1 to
3 are available on that connector. The connector labeled CH. B I/O has
the contacts for relays 4 to 6. In Figure 4-10, the labels on the pins
apply to either connector. Example: #1/4 COM refers to the wiper of
relay 1 if it is connected to CH. A and the wiper of relay 4 if it is
connected to CH. B.
Ports
Rear View of IMF-3 Frame
GPI/RLY
Interface
Connector
RJ-45 RJ-45 RJ-45 RJ-45 RJ-45
DB-9 DB-9 DB-9 DB-9 DB-9
RJ-45 RJ-45 RJ-45 RJ-45 RJ-45
DB-9 DB-9 DB-9 DB-9 DB-9
Other
Interfaces
RLY-6
#2
GPI-6
#2
GPI-6
#1
RLY-6
#1