Clear-Com Eclipse-PiCo - Manual (Page 51)

Clear-Com Communication Systems
Eclipse PiCo Matrix Instruction Manual 4 - 1 3
Figure 4-10: RLY-6 Interface DB-9M Connector Pinout
IMF-102 Interface Module Frame Wiring
The wiring of a RLY-6 interface that is placed in an IMF-102 interface
frame is the same as the wiring for a RLY-6 interface placed in an
IMF-3 interface frame. The only difference is that an IMF-102 interface
frame houses only two interfaces, and they are mounted horizontally
rather than vertically in the frame.
Refer to the respective manuals for these interfaces and frames in the
Eclipse manual set for more information.
Configuration
To associate a relay to a label, use the Eclipse Configuration System,
(ECS) as described in the ECS manual.
GPI-6 Interface Wiring
The GPI-6 input interface module connects up to six programmable
inputs to the matrix so that each input can control a predefined matrix
function. Multiple GPI-6 interfaces can be daisy-chained to provide
connection of up to 60 inputs to the matrix. RLY-6 and GPI-6 interfaces
can be mixed together up to the total limit of 60 items. Five RLY-6 and
five GPI-6 interfaces would provide 30 relays and 30 inputs for a total
of 60 inputs and outputs.
Note: If both GPI-6 and RLY-6 interfaces are used the GPI-6
interfaces are required to be placed first in the daisy chain.
1
2
9
8
7
6
5
4
3
#1/4 Normally Open
#2/5 COM
#3/6 Normally Open
#1/4 Normally Closed
#1/4 COM
#2/5 Normally Closed
#2/5 Normally Open
#3/6 Normally Closed
#3/6 COM