Clear-Com Eclipse-PiCo - Manual (Page 39)

Clear-Com Communication Systems
Eclipse PiCo Matrix Instruction Manual 4 - 1
INSTALLING AN ECLIPSE
PICO MATRIX
VERIFYING THE SHIPMENT
When the Eclipse PiCo system is received inspect the boxes for
shipping damage. Report any shipping damage to the carrier. The
Eclipse PiCo distributor is not responsible for shipping damage.
Check the packing list and verify that every item on the list has been
received. Save all packing materials in the event any items need to be
returned.
UNPACKING THE SYSTEM
The system will include an Eclipse PiCo matrix which contains the
hardware, and the software for the system. The user will need to
supply:
• A standard 19 inch wide (48.26 cm) Electronics Industry Association
rack in which to install the matrix.
• A personal computer to run the Eclipse Configuration System
programming software (ECS). The Eclipse Configuration System
software runs on Windows 2000, Windows XP, Windows Server
2003 and Windows Vista (with restrictions). When running ECS on
Windows operating systems, the client and server can run on
separate machines connected over a network.
• Shielded category-5 cables to connect to panels and interfaces.
INSTALLING THE ECLIPSE PICO MATRIX
The following overview gives a summary of the steps required to install
an Eclipse PiCo matrix. More detailed information on each step is
provided in the sections that follow.
To install an Eclipse PiCo matrix:
1. Remove the Eclipse PiCo matrix from its shipping carton.
2. Place the matrix in a standard Electronic Industry Association
equipment rack.
3. Leave at least 2 inches (51 mm) of clearance on all sides of the
matrix to ensure proper airflow. Do not block ventilation vents.
4. Connect the power supplies to AC mains power using the IEC
connectors on the matrix’s rear panel. The matrix has two separate
AC power entry connectors for the two separate power supplies in
the system.
4