Clear-Com Eclipse-PiCo - Manual (Page 32)

Clear-Com Communication Systems
Eclipse PiCo Matrix Instruction Manual
3 - 8
The System menu appears.
2. From the System menu, select IP ADDRESS.
The IP Address menu appears. If the matrix software has been
reloaded or reset the default IP address of 172.16.2.100 will be
displayed.
3. Scroll to the first digit of the IP Address.
4. Press the setup/enter knob.
5. Rotate the setup/enter knob clockwise or counterclockwise to scroll
through the available digits.
6. When the desired digit appears in the display, press the setup/enter
knob to select and save it.
7. Rotate the setup/enter knob clockwise or counterclockwise to scroll
to the next digit and repeat steps 4 through 6.
8. Repeat step 7 as many times as needed to enter the entire IP
address.
9. Repeat the same procedure for the Subnet Mask field.
10. Scroll to and select SAVE.
A confirmation screen appears asking for confirmation of the
selection. Select YES to accept the new IP address. Select NO or
EXIT to cancel any changes and revert to the current settings. The
Reset Options menu appears.
11. Select one of the following from the Reset Options menu.
• APPLY AND RESET resets the system to the currently selected
configuration, while restoring active calls and activating any
changes made from the PiCo’s front panel since the last reset.
• CLEAR XPOINTS resets the system to the currently selected
configuration, while clearing active calls and clearing any changes
made from the PiCo’s front panel since the last reset.
The PiCo now has the IP address selected.
12. To exit the menu. scroll to and select EXIT.
RESETTING TO THE DEFAULT IP ADDRESS
The Eclipse Pico can also be reset to the default IP addresses using
the internal reset buttons (see the chapter on Operations). This will
reset the LAN ethernet port to the factory default address of
172.16.2.100. This procedure is not normally required as the IP
address can be set from the front panel as described above.