Clear-Com Eclipse-PiCo - Manual (Page 25)

Clear-Com Communication Systems
Eclipse PiCo Matrix Instruction Manual 3 - 1
USING THE PICO
FRONT PANEL
MENUS
Using just the front-panel controls and display menus the system
operator can perform a variety of actions directly from the PiCo matrix,
without any need for the Eclipse Configuration System (ECS)
programming software. For example the system operator can:
• Check whether a connected panel is online and communicating with
the matrix
• Adjust incoming and outgoing audio levels for a panel connected to
the matrix
• Create audio routes between audio devices connected to the PiCo
matrix
• Select and activate one of the four available onboard configuration
maps
• Allocate an IP address to the matrix so that it can operate on a
network
• Access information about system number and firmware version
• Access status of high-speed link and local area connection
• Select a source and destination of Identification Tone
• Reset the system to apply locally made changes
• Check whether or not general purpose inputs and outputs are on
• Switch general purpose outputs on and off
STARTING FROM THE MAIN MENU
When the system is first powered up the “Clear-Com Eclipse PiCo”
screen appears. When the setup/enter knob is pressed the main menu
appears, as shown in Figure 3-1.
Figure 3-1: Main Menu
MAIN MENU
AUDIO ROUTING CONFIGS STATUS
EXIT
SYSTEM
The system operator can get
information or select system
options using the PiCo’s
front-panel menus.
Scroll to an item by turning
the setup/enter knob. Select
an item by pressing the knob
in, as if it were a pushbutton.
3