Clear-Com V24PDXY - Manual (Page 3)

Clear-Com Communication Systems V-Series AES-3 Option
© Clear-Com Communication Systems 3 PN 810388Z Rev. 2
Fitting the AES-3 Option Card to Rack Mount Panels
Before fitting the AES-3 card the panel must be completely disconnected and
removed from any rack or console. Place the panel on a clear workspace
suitable for antistatic precautions.
Step 1
The power supply should be removed from the cradle at the back of the panel
if it has been fitted there (see Figure 3). If the power supply is not fitted in the
cradle proceed to step 2.
Figure 3: Power Supply in Cradle on Rack Mount Panel
Unlock the power connector from the panel by turning the outer ring
anticlockwise then pulling the connector. Remove the power supply block by
pulling it out of the rear of the cradle (Figure 4).
Figure 4: V-Series Rack Mount Panel with PSU Removed