Clear-Com V24PDXY - Manual (Page 20)

V-Series AES-3 Option Clear-Com Communication Systems
PN 810388Z Rev. 2 20 © Clear-Com Communication Systems
Step 8
Use the two panhead screw and washer assemblies to fix the AES-3 card to
the spacers (see Figure 24).
Note: A “stubby” or short handled screwdriver is required for this
operation.
Figure 24: AES-3 Option Card with Mounting Screws
Step 9
Replace the DSP card in the slot at the rear of the motherboard ensuring that
it is securely held by the clips.
Step 10
Replace the front panel assembly ensuring it is replaced in the correct
orientation noted in step 1, making sure that the correct screws are used (see
Figure 15).
Insert the microphone connector edge into position first, then lower the
headset connector into place.
Note: Ensure that no cables are trapped before attempting to refit the
screws.
Apply pressure to the lid to align the screw holes and fit the top and bottom
screws loosely on each side before fitting the remaining screws and tightening
all the screws.