Hydra-Tech S3VHLDI User Manual
3” hydraulic submersible sludge / slurry pump, Features, Model s3vhl

MODEL S3VHL
(Aluminum Body)
MODEL S3VHLDI
(Ductile Iron Body)
3” (75 mm) Discharge
3” HYDRAULIC SUBMERSIBLE
SLUDGE / SLURRY PUMP
The S3VHL is designed to pump sludge,
slurries and liquids with stringy solids.
Uses for this pump include liquid manure
pumping, water treatment slurries and
clarifier tanks. This versatile pump is
offered in aluminum or ductile iron
construction.
FEATURES
•
Small Overall Size allows pump to fit
through a 20" diameter opening
•
Oil Lubricated Seals (can run dry)
•
Variable Speed hydraulic drive
•
Fully Recessed Vortex Impeller
(will pass 3" semi-solids)
•
Can be bolted directly into a pipeline or
fitted with a suction hose for underwater
dredging
•
Safe Hydraulic Drive can be used where
electric power is hazardous or impractical
•
Dependable gear type hydraulic motor
•
Operates with our HT15 to HT35 power
units or other hydraulic power sources
capable of flows of 10 - 18 GPM
D0413
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website
WEIGHT: (Aluminum)................................... 176 lbs. (80 kg)
(Ductile Iron)............................. 289 lbs. (131 kg)
HEIGHT:............................................................. 33" (84 cm)
WIDTH(@ widest point):............................. 19 3/4" (50 cm)
DISCHARGE:...................................................... 3", NPT(F)
INLET FLANGE:.................Drilled for 3" and 4", 125# ASA
SOLIDS HANDLING:.............................................. 3" (8 cm)
HOSE PORTS:................................................ 1" (-16) SAE
PUMP BODY: (S3VHL)................. Heat Treated Aluminum
(S3VHLDI)................................. Ductile Iron
IMPELLER:................................................... Stainless Steel
WEAR RING and WEAR PLATE.................. Stainless Steel
SHAFT:......................................................... Stainless Steel
SHAFT SEAL:.................................... Carbon/Ceramic (Std)
Silicon Carbide (Optional)
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:.................................. Max 18 GPM (68 LPM)
OPERATING PRESSURE:............ Max 3000 PSI (204 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System
SPECIFICATIONS
Specifications are subject to change without notice