Hydra-Tech S3TDI User Manual
3” hydraulic submersible, Vortex flow trash pump, Features
MODEL S3T
(Aluminum Body)
MODEL S3TDI
(Ductile Iron Body)
3” (75 mm) Discharge
3” HYDRAULIC SUBMERSIBLE
VORTEX FLOW TRASH PUMP
Our S3T model is designed for jobs such
as construction sites and manhole
pumping where lightweight, high volume,
trash pumps are needed. It has the
ability to pass through a 12" opening and
pump in debris laden areas. A small hole
strainer is available for limiting solids to
be pumped.
FEATURES
•
Stainless Steel Vortex Flow Impeller
•
Oil Lubricated Seals (can run dry)
•
Variable Speed hydraulic drive
•
Small overall size for use tight spaces
•
Can be bolted directly into a pipeline
•
Safe Hydraulic Drive can be used where
electric power is hazardous or impractical
•
Dependable gear type hydraulic motor
•
Operates with our HT11 to HT15 power
units or other hydraulic power sources
capable of flows of 5-8 GPM
C0109
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website
:
WEIGHT S3T:.............................................. 25 lbs. (11 kg)
S3TDI:........................................... 48 lbs. (22 kg)
HEIGHT:............................................................. 14" (36 cm)
WIDTH (@ widest point):.............................. 11 3/4" (30 cm)
DISCHARGE:....................................................... 3" NPT(F)
INLET FLANGE:.............................................. 3", 125# ASA
SOLIDS HANDLING:.................................... 2 1/2" (63 mm)
HOSE PORTS:..................................................1/2" NPT (F)
PUMP BODY S3T:.............................................. Aluminum
S3TDI:........................................ Ductile Iron
IMPELLER:.................................................... Stainless Steel
WEAR RING....................................................... Ductile Iron
SHAFT:..................................................... Plated 4140 Steel
SHAFT SEAL:.................................... Carbon/Ceramic (Std)
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:.................................... Max. 8 GPM (30 LPM)
OPERATING PRESSURE:............ Max. 2500 PSI (170 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System
SPECIFICATIONS
Specifications are subject to change without notice