Hydra-Tech S4VHLDI User Manual
4” hydraulic submersible sludge / slurry pump, Features, Model s4vhl

MODEL S4VHL
(Aluminum Body)
MODEL S4VHLDI
(Ductile Iron Body)
4” (100 mm) Discharge
4” HYDRAULIC SUBMERSIBLE
SLUDGE / SLURRY PUMP
The S4VHL is designed to handle wastewater
and sewage and will fit through a 20" diameter
manhole . Primary uses for this pump are:
Sewer by-pass into force mains and general
transfer of solids laden fluids. This versatile
pump is offered in aluminum or ductile iron
construction.
FEATURES
C0413
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website
SPECIFICATIONS
Specifications are subject to change without notice
•
Small Overall Size allows pump to fit
through a 20" diameter opening
•
Oil Lubricated Seals (can run dry)
•
Variable Speed hydraulic drive
•
Fully Recessed Vortex Impeller
(will pass 3" semi-solids)
•
Can be bolted directly into a pipeline or
fitted with a suction hose for underwater
dredging
•
Safe Hydraulic Drive can be used where
electric power is hazardous or impractical
•
Dependable gear type hydraulic motor
•
Operates with our HT25 to HT60 power
units or other hydraulic power sources
capable of flows of 14 - 26 GPM
WEIGHT: (Aluminum)................................... 160 lbs. (72 kg)
(Ductile Iron)............................. 265 lbs. (120 kg)
HEIGHT:............................................................. 33" (84 cm)
WIDTH(@ widest point):............................. 19 3/4" (50 cm)
DISCHARGE:...................................................... 4", NPT(F)
INLET FLANGE:............................................ 4", 125# ASA
SOLIDS HANDLING:.............................................. 3" (8 cm)
HOSE PORTS:................................................ 1" (-16) SAE
PUMP BODY: (S4VHL)................. Heat Treated Aluminum
(S4VHLDI)................................. Ductile Iron
IMPELLER:................................................... Stainless Steel
WEAR RING and WEAR PLATE.................. Stainless Steel
SHAFT:......................................................... Stainless Steel
SHAFT SEAL:.................................... Carbon/Ceramic (Std)
Silicon Carbide (Optional)
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:.................................. Max 26 GPM (98 LPM)
OPERATING PRESSURE:............ Max 3000 PSI (204 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System