Burkert Type 8605 - Manual (Page 16)

16
Installation
8. INSTALLATION
8.1. Safety instructions
DANGER!
Risk of injury from high pressure in the equipment!
• Before loosening the lines and valves, turn off the pressure and vent the lines.
Risk of injury due to electrical shock!
• Before reaching into the device or the equipment, switch off the power supply and secure to prevent
reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
WARNING!
Risk of injury from improper installation!
• Installation may be carried out by authorised technicians only and with the appropriate tools!
Risk of injury from unintentional activation of the system and an uncontrolled restart!
• Secure system from unintentional activation.
• Following assembly, ensure a controlled restart.
8.2. Electrical connections
DANGER!
Risk of injury due to electrical shock!
• Before reaching into the device or the equipment, switch off the power supply and secure to prevent
reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
8.2.1. Cable plug version
The electrical connection of the Controller Type 8605 in cable plug version is made via a 4-pin terminal strip inside
the device.
Cable:
• Diameter 6 ... 8 mm
• Cross-section max. 0.75 mm²
• Cable connections Cable gland or plug connector M12
4-pin
english
Type 8605