Draw-Tite 1370400 BIKE CARRIER - SPORTWING - HITCH MOUNT - Manual (Page 2)

Item:
Description:
1370400
Cequent Consumers Products
29000-2 Aurora Road
Solon, OH 44139
Technical Service: (800) 234-6992
1370400N Rev A 10-08
Printed in China
Aluminum SportWing
™ 4 Bike Carrier
Page 2 of 3
CENTER TO CENTER
DISTANCE – BIKE WHEEL
FIGURE 6
CENTER TO CENTER
DISTANCE - WHEEL HOOK
WHEEL HOOK
ARM SUPPORT
LOADING THE BIKE(S)
8.
Determine the appropriate setting for the wheel hook assemblies by measuring the “center to center” distance of the bike
wheels.
9. Adjust the wheel hook assemblies to match the “center to center” bike wheel distance by sliding assembly along the arm
support. (Figure 6)
10. Firmly tighten the handles to secure wheel hook in position.
11. Load the largest bike first on the vehicle side using the lower wheel hooks. (Figure 8)
12. Start with front wheel, and hang from wheel hook as shown in Figure 8.
13. Then mount the rear wheel on the opposite hook.
14. Secure both wheels by firmly attaching the rubber strap. (Figure 8)
15. Use two (2) Hook & Loop straps to hold the bike frame to the bike carrier arm supports as shown.
16. To load two middle bikes, loosen T-Handle and slide telescoping tube out allowing access to middle mounting hooks. (Figure
7)
17. Load the remaining bikes so that the handle bars are in the opposite direction of the previous bike. Repeat steps 6, 7, 8 and 9.
18. Once all bikes are loaded, slide bikes together and re-tighten T-handle.
HANDLE
RUBBER STRAP
RUBBER STRAP
HOOK & LOOP STRAP
HOOK & LOOP STRAP FIGURE 7 FIGURE 8