beautypg.com

Draw-Tite 24759 SPORTFRAME HITCH User Manual

Installation instructions, Chrysler pt cruiser, Part numbers

background image

Chrysler PT Cruiser

Part Numbers:

77135

24759

60818

Hitch Shown In Proper Position

Wiring Access Location: SUV 1, SUV 2

Equipment Required:

Wrenches: 3/4”, 15mm, 17mm
Drill Bits: 1/2”
Screwdriver

1.

Remove tow hooks if present. Return tow hooks & fasteners to owner.

2.

Remove both taillights by removing screw at bottom of light cover.

3.

Lower exhaust at (2) hangers, (1) at front and (1) at rear of muffler.

4.

Position hitch as shown and install M10 fasteners provided.

5.

Using hitch as a template, drill 1/2” holes in (2) places.

6.

Fishwire carriage bolt and block through access holes in taillight openings, as shown.

7.

Torque all fasteners to specifications shown below.

8.

Re-install exhaust hangers and taillights.

Tighten all M10 CL8.8 fasteners with torque wrench to 38 Lb.-Ft.

Rev. A

10-04-05

24759N

Sheet 1 of 3

z

2005 Cequent Towing Products

3/8” Conical washer

Qty. (4)

6

1/2” Lock washer

Qty. (2)

3

M10 X 1.50 X 35mm CL8.8 Hex bolt

Qty. (4)

5

1/4” X 1-1/2” X 2” Block

Qty. (2)

2

1/2” Hex nut

Qty. (2)

4

1/2”-13 X 1-3/4” Carriage bolt

Qty. (2)

1

Tighten all 1/2” fasteners with torque wrench to 75 Lb.-Ft.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

2000 LB Max Gross Trailer Weight

200 LB Max Tongue Weight

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Drawbar must be used in the
RISE position only.

Drawbar Kit:

3593

Fastener Kit: 24759N

Bumper

Frame

Installation Instructions

1

2

3

5

4

6

Frame rails

Existing weld nuts,
Typical both sides

Drilled holes
both sides

Position blocks
as shown

Typical both sides

Typical both sides

Typical both sides

Taillight
access