beautypg.com

Draw-Tite 36474 FRAME HITCH User Manual

Installation instructions, Volkswagen tiguan, Figure 2

background image

Installation Instructions

Volkswagen Tiguan

Part Numbers:

06625

36474

90191

Hitch Shown In Proper Position

Wiring Access Location: PC1, PC2

Equipment Required: Utility Knife

Wrenches: 17mm

Drill Bits: None

1.

Locate existing grooved area on bottom of fascia to be cut as shown in Figure 2. Cut fascia as shown to access
mounting holes in vehicle cross member.

2.

Raise hitch into position, aligning holes in hitch top plate with holes in vehicle cross member.

3.

Secure with M10 x 1.50 x 70mm hex bolts and 3/8” conical toothed washers.

Rev. A

5-27-08

36474N

Sheet 1 of 3

z

2008 Cequent Towing Products

Conical Toothed Washer 3/8”

Qty. (4)

2

Hex Bolt M10 x 1.50 x 70mm CL8.8

Qty. (4)

1

Tighten all M10 CL8.8 fasteners with torque wrench to 38 Lb.-Ft. (52 N*M)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent

entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a

vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and

SAE J684.

3500 LB (1589 Kg) Max Gross Trailer Weight

300 LB (136 Kg) Max Tongue Weight

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Drawbar must be used in the
DROP position only.

Drawbar Kit:

36051

Fastener Kit: 36474F

Form F206 Rev A 5605

Note: Fascia Trimming Required. Obtain Vehicle

Owner’s Approval Before Cutting

Note: Fascia Trimming Required. Obtain Vehicle Owner’s Approval Before Cutting.

Fascia

6-1/2”

(165mm)

Area to be cut for
Hitch Installation

Existing Grooved Area
In Vehicle Fascia

1

2

Hitch Top Plate

Vehicle Cross Member

Existing
Weldnuts

Figure 2

(Looking up from under vehicle)

Fascia trimming diagram

1

2

Figure 1

Fascia not shown for clarity