beautypg.com

Draw-Tite 75649 MAX-FRAME RECEIVER User Manual

Installation instructions, Toyota sequoia, Figure 1 figure 2

background image

Installation Instructions

Toyota Sequoia

Part Numbers:

44602

75649

87488

Hitch Shown In Proper Position

Equipment Required: Keyhole Saw

Wrenches: ¾”

Drill Bits: ½” (Optional – See Step #4)

1.

Lower spare tire.

2.

Trim rigid foam fascia support on both forward and rearward sides of vehicle impact bar as shown in Figure 2 (approximately 10-

1/4” wide and 1-1/8” above top of vehicle impact bar) to allow hitch brackets to fit flat against impact bar.

3.

Raise hitch into position, centering hitch on vehicle. Mark foam fascia support at bolt holes in hitch.

4.

Take hitch down and, using ½” drill bit or keyhole saw, cut foam to allow ½” bolts to pass over top of impact bar.

5.

Raise hitch back into position and secure with ½” x 4.5” hex bolts and lock washers into ½” nuts on rearward hitch bracket.

6.

Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)

7.

Raise spare tire back into position.

Rev. A

3-4-08

75649N

Sheet 1 of 3

z

2008 Cequent Towing Products

Lock Washer ½”

Qty. (3)

2

Hex Bolt – ½-13 x 4.500 GR5

Qty. (3)

1

Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent

entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle

and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and

SAE J684.

Fastener Kit: 75649F

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

600 (272 Kg.)

6000 (2724 Kg.)

Weight Carrying

Ball Mount

1000 (454 Kg.)

10,000 (4540 Kg.)

Weight Distributing

Max Tongue

WT (LB)

Max Gross

Trailer WT (LB)

Hitch type

Wiring Access Location: TBD

Form: F205 Rev A 5-6-05

Plastic Fascia

Rigid Foam Fascia
Support - Modified

Vehicle Impact Bar

Vehicle Impact
Bar

1

2

Figure 1

Figure 2

10.250

Top of Impact Bar

Showing Rigid Foam Fascia
Support Modification for
Hitch Installation

(260 mm)

1.125

(29 mm)

Drill or cut foam
To allow ½” bolts
To pass over top
Of impact bar-
3 places

Trim foam on both forward and rearward
sides of vehicle impact bar to clear hitch
bracket