Draw-Tite 75715 MAX-FRAME RECEIVER - Manual

Installation Instructions
Nissan NV 1500, 2500, & 3500 (All Models)
Part Numbers:
44664
75715
87610
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 17mm
Drill Bits: None
1. Raise hitch into position aligning holes in hitch with existing weldnuts in bottom of frame.
2. Install M12 bolts into weldnuts (8) places and tighten to specified torque below.
z 2011 Cequent Performance Products, Inc Sheet 1 of 3 75715N 4-19-11 Rev. A
1 Qty. (8) Hex Bolt – M12 x 1.25 x 39mm CL10.9
Tighten all M12 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75715F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 10,000 (4535 Kg) 1000 (454 Kg)
Weight Carrying
Ball Mount
7500 (3401 Kg) 1125 (510 Kg)
Wiring Access Location: TBD
Form: F205 Rev A 5-6-05
Frame
Step
Bumper
1
Existing
Weld Nuts
In Frame