Draw-Tite 75095 MAX-FRAME RECEIVER User Manual
Installation instructions, Lexus lx470 toyota landcruiser, Part numbers

Installation Instructions
Lexus LX470
Toyota Landcruiser
Part Numbers:
87409
75095
44546
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 12mm, 19mm & 7/8”
Drill Bits: NONE
Other: Phillip’s Screwdriver
Tighten all M12 CL10.9 fasteners with torque wrench to 130 Lb.-Ft (176 N*M).
Rev. A
01-30-06
N75095
Sheet 1 of 6
z
2006 Cequent Towing Products
9/16” Lock Washer
Qty.
(1)
9/16” Hardened Flat Washer
Qty.
(1)
M14 x 1.50 x 45mm CL10.9 Hex Bolt
Qty.
(1)
1/2”-13 Hex Nut
Qty.
(1)
1/4” x 1-1/2” x 2” Block
Qty.
(1)
1/2”-13 x 1-3/4” GR8 Carriage Bolt
Qty.
(1)
½” Conical Washer
Qty.
(2)
M12 x 1.25 x 40mm CL10.9 Hex Bolt
Qty.
(1)
Tighten all 1/2” GR8 fasteners with torque wrench to 110 Lb.-Ft (149 N*M).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
Fastener Kit: 01131-066
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
500 (227kg)
5000 (2270kg)
Weight Carrying
Ball Mount
750 (341kg)
6000 (2724kg)
Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV6
Tighten all M14 CL10.9 fasteners with torque wrench to 148 Lb.-Ft (201 N*M).
Tighten all existing OEM M14 fasteners with torque wrench to 80 Lb.-Ft (108 N*M).
1
2
3
4
5
6
7
8
Fascia
1
2
3 4
5
6
7 8
2
Existing fastener, typical both sides.
Existing bolt, (6) places.
Existing weldnut, (2) places.
Tie-down bracket, (from driver’s side).
Existing OEM bolts;
M14 x 1.50 x 56mm hex bolts, (short).
SHORT
LONG
Existing OEM bolts; M14 x 1.50 x 63mm hex bolts, (long).
Tow hook
Tie-down bracket,
(from passenger side).
Fascia support bracket
Frame rail
Existing weld-nut
(3) places.
Crossmember
Access hole
Depending on vehicle
configuration use
one or the other.