Draw-Tite 75531 MAX-FRAME RECEIVER User Manual
Installation instructions, Mazda cx-9, Part numbers

Installation Instructions
Mazda CX-9
Part Numbers:
75531
87438
44572
78223
U-Haul
Do Not Exceed Lower of Towing Vehicle
Fascia
Frame rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75531F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing
4000 (1816 Kg)
400 (182 Kg)
Weight Carrying
Ball Mount
4000 (1816 Kg)
400 (182 Kg)
Wiring Access Location:
Heat shield
Wrenches: 19mm
Drill Bits: None
Frame rail
Fastener Kit: 75531F
Existing weld nut
Fasteners typical both sides
Heat shield
21
Receiver tube
1.
Raise hitch into position between frame rails, pointing the receiver tube down and rotating it into
position above the muffler and heat shield. Note: The hitch might touch the heat shield during
1
Qty. (6)
Hex bolt M12 X 1.25 X 25 CL 8.8
2
Qty. (6)
Conical Washer
position above the muffler and heat shield. Note: The hitch might touch the heat shield during
installation.
2.
Install fasteners as shown.
3.
Push hitch rearward and tighten.
z
2007, 2010 Cequent Performance Products
Sheet 1 of 3
75531N
10-14-10
Rev. B
Tighten all M12 CL8.8 fasteners with torque wrench to 76 Lb.-Ft. (105 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form: F205 Rev A 5-6-05