Draw-Tite 75684 MAX-FRAME RECEIVER - Manual

Installation Instructions
Hyundai Santa Fe
Kia Sorento
Part Numbers:
87574
75684
44639
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 16mm
Drill Bits: None
1. Raise car on ramps, hoist, or jack stands.
2. Raise hitch into position, installing fasteners as shown into existing weldnuts in vehicle frame.
Rev. B 2-5-10 75684N Sheet 1 of 3 z 2009, 2010 Cequent Performance Products
Conical Toothed Washer – 7/16” Qty. (4) 2 Hex Bolt – M10 x 1.25 x 30mm Qty. (4) 1
Tighten all M10 x 1.25 CL10.9 fasteners with torque wrench to 59 Lb.-Ft. (80 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
Fastener Kit: 75684F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
350 (159 Kg.) 3500 (1589 Kg.)
Weight Carrying
Ball Mount
500 (227 Kg.) 5000 (2270 Kg.) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: Santa Fe: SUV3, SUV4
Sorento: SUV7
Form: F205 Rev A 5-6-05
Frame Rail
Exhaust
Weldnuts in Vehicle
Frame Rail-Typical
Fascia
Fasteners Typical
Both Sides
12