Draw-Tite 75713 MAX-FRAME RECEIVER - Manual

Installation Instructions
Dodge Durango
Part Numbers:
Do Not Exceed Lower of Towing Vehicle
Frame rail
Fascia
75713
87608
44662
Hitch Shown In Proper Position
Equipment Required:
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 7500 (3405 Kg) 750 (341 Kg)
Weight Carrying
Ball Mount
6000 (2724 Kg) 600 (272 Kg)
Wiring Access Location: SUV1, 2
Fascia
Wrenches: 21mm
Fastener Kit: 75713F
Frame rails
Existing weldnut
Note: Fasteners typical
both sides
Retain bolt for
reinstallation.
g
both sides
1. Lower the spare tire.
2. Remove (4) existing M14 bolts (Do Not clean the threads). Retain bolt for reinstallation.
Note: Uses all
existing Bolts
on Vehicle
3. Raise hitch into position as shown and install fasteners as shown. If excess caulking on the
frame rail interferes with hitch installation lower hitch and scrape excess caulking for installation.
4. Tighten all fasteners to called-out torque specification.
5. Raise spare tire back into position.
Tighten all M14 fasteners with torque wrench to 115 Lb.-Ft. (156 N*M)
z 2011 Cequent Performance Products Sheet 1 of 3 75713N 1-27-11 Rev. A
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
F F205 R A 5 6 05